Rural Lifestyle

Life in Rural America

Tag: chicken coop security

Chicken Coop Project Part 3

Chicken coopUnlike a lot of people that spent Easter weekend going to church and hunting easter eggs, I spent my weekend working on a chicken coop.

Friday morning my wife and I loaded up in the truck, grabbed some lunch at McDonalds, then we went to Parkers lumber in Jasper Texas to get supplies for the chicken coop.

This is what we bought at Parkers:

36 inch x 1/2 inch squares hardware cloth, 10 foot roll
Paint tray
1 box 1 1/2 inch roofing screws with rubber washer
Extra bits for the drill
Skil saw blade
Exterior latex redwood stain paint
14 – treated 2x4s 8 feet long

Chicken coop project part 1

Chicken coop project part 2

More chicken coop ideas

Raising chickens for SHTFIn the previous article we built the first 1/2 – 1/3 of the chicken coop. Now its time to look at building the rest of the coop.

During the final stages of the coop construction, there are 3 things I want to focus on:

Security
Lights
Exhaust fan for the coop – this is a “maybe”

Lets see if we can break this down:

1 solar panel for the hotwire
1 solar panel for the 12 volt battery for lights and exhaust fan

My orginal plans were to run the light, fan and hotwire off one solar unit and a single 12 volt battery. But since the hotwire system has a 6 volt battery,I am going to have to go with 2 solar units. 1 solar for the 6 volt battery and hot wire, 1 solar unit with 12 volt battery for lights and fan.

Chicken Coop Project Part 2

Chicken coopThe first part of the coop was thrown together because rain was on the way. It was either get a section of the coop built and get the roof on it, or everything was going to get wet. Due to the rush, certain things were left off the coop during the first weekend, such as a vent window, the ladder,,, and a few other small details.

March 24 and 25 another door was added to the coop, the egg collection door was finished, the ladder was finished, and a vent window was added.

The second door was cut 24 inches by 24 inches square. The other door which measures 18 inches wide seemed a little narrow. The rugs of the ladder are spaced at 1.5 inches apart. To keep the spacing the same, I used a 2×4 on its side as a spacer. The problem is, 1.5 inches between the boards leaves a large gap for a snake to get through. To hopefully keep the snakes out, 1/2 inch square hardware cloth was stapled to the bottom to the ladder.

The ladder was completed, except for a draw string to raise and lower the ladder from outside the coop. But then again, I am thinking about not using a string and just reaching through the door to lift the gate by hand. Whether a string is used or not depends on how much chicken crap is on the ladder. If the ladder is covered with crap, its getting a pull string installed.

Page 1 of 11
Kevin Felts © 2008 - 2018